Aggregate Calculator
Estimate aggregate needed in tons, cubic yards, or bags for base layers and fills.
Use these calculators to estimate quantities, coverage, and materials for common construction projects.
CalcShed's construction calculators cover material takeoffs, roof geometry, framing quantities, and common conversions. Choose the tool for your task and check its dimensions, assumptions, and purchase units before ordering.
Estimate aggregate needed in tons, cubic yards, or bags for base layers and fills.
Calculate asphalt quantity by area and thickness. Outputs tons and cubic yards with waste.
Required NFVA, intake and exhaust targets, vent counts, continuous vent length, and existing-system deficits.
Estimate bricks per square foot plus mortar bags for any wall, with waste.
Estimate cement required by volume or bags with common mix assumptions.
Convert slab/footing volume into 60 lb and 80 lb bag counts with waste.
CMU block counts, exact opening deductions, block overage, and source-labeled mortar quantities.
Estimate concrete volume for strip or pad footings based on dimensions.
Estimate slab concrete volume in cubic yards and bag equivalents.
Deck-board quantities from exact sections, board gap, stock length, layout, and physical cut yield.
Estimate fence posts, rails, and pickets by total fence length and height with waste included.
Calculate studs, top plates, and bottom plates for wall framing by length and ceiling height.
Estimate gravel quantity for driveways and base layers in tons and cubic yards.
Calculate board feet and lumber cost by thickness, width, and length for any framing or woodworking project.
Estimate metal roofing coverage and panel quantities with waste.
Estimate paver count and base materials by patio area with waste.
Concrete volume and bag counts for round post holes with actual post displacement and mixed post groups.
Estimate ready-mix order size in cubic yards from project dimensions.
Estimate rebar grid, spacing, linear feet, and weight by slab size.
Estimate retaining wall blocks, drainage gravel, and material cost by wall length and height.
Estimate roof area with pitch adjustment from footprint dimensions.
Calculate roof pitch from rise/run and convert between common pitch formats.
Estimate basic truss dimensions from span, pitch, and overhang.
Estimate roofing materials by squares, bundles, and waste percentage.
Estimate sand required for base layers and leveling in yards and tons.
Estimate shingle bundles and squares needed with waste and ridge cap allowance.
Whole soffit panels from multiple eave runs, product coverage, stock length, and physical cut yield.
Estimate concrete needed for cylindrical post holes using sonotube diameters.
Calculate stair rise, run, tread dimensions, and step count from the measured height.
Tools for concrete (slabs, footings, bags, ready-mix), roofing (pitch, squares, trusses), framing (studs, lumber, board feet), and masonry (brick, retaining wall), plus aggregates, pavers, and asphalt.
Results depend on your measurements, the material or product assumptions, and the calculation used. Treat them as planning estimates; confirm product quantities and code-related requirements for the actual job.
Some calculators let you add material overage for cuts, breakage, or handling. Where an option is provided, use an allowance appropriate to the product, layout, and supplier guidance.
No. These tools provide quantities or geometry, not permit approval or an engineered design. Check requirements such as footing depth or reinforcement with the applicable code and qualified professional.
We use cookies to analyze site traffic. Privacy Policy